• Insulation Piercing Connectors BARE NETWORK

Insulation Piercing Connectors BARE NETWORK


※This connector is used to connect a low voltage A.B.C.(Aerial Bundled Conductors) network to another low voltage bare conductors network.

※Tightening of the bare main conductor and piercing of the tap conductor are carried out simultaneously in a single tightening operation.
※The tightening screw is potential free.
※Tightening efficiency is ensured by a shear head screw.
※The connector end cap is flexible so that to feel good tap conductor insertion simply by hand. It is carrying grease, granting water-tightness around tap conductor end on long terms basis. It is linked on connector body so that to avoid eventual loss during handling, installation and environment (wind, wild life…).
※This connector is according to the criteria of NF C 33-020 and EN 50-483.

• Insert the insulated tap conductor into the connector so that its end seats in the flexible end cap.
• Use a spanner and tighten the connector on to the bare main conductor until the shear head breaks.
• The permanent screw head is only provided for possible dismantling, and must not be used to re-tighten the screw after the first head has broken.
• Implementation can be carried out on a live line but with no load on the tap conductor.

Part No. Item Mains Insulated
Al-Cu mm²
Tap Insulated
Al-Cu mm²
Number of Bolts
B010108 IPCN 7-100/25-95 7-100 25-95 1